KB594 Is Digitrax signaling and detection equipment compatable with other DCC systems?

Q: I have a Lenz Set 100 and was wondering if I can use my DCC system and use the Digitrax signaling and detection components. What about other DCC systems?A: Yes, Digitrax detection and signaling will work with any DCC system.  You will need to install a LocoNet network for the LocoNet components to communicate with each other and use a PR3 or MS100 to interface with a computer running software such as Railroad and Co. 

KB877 Programming the Digitrax DA120 Decoder Installed in Atlas Locos With Wangrow and Lenz Systems

This application note concerns the DA120 deocder, which began production in 1997 and was discontinued around 2000. The DA120 decoder that is being shipped with the Atlas locomotives has certain variables that are available for programming. These guidelines are provided for those who are using the Wangrow or Lenz systems for programming the DA120 decoders.The following variables were selected by Atlas to be offered in the DA120. These CV's are available to be programmed on the DA120:    * CV01 - Address    * CV02 - Start Voltage    * CV03 - Acceleration Rate    * CV04 - Deceleration Rate    * CV05 - Maximum ...