Accessories

Dual Current, Protected Splitter Cable. For use wth PS2012 power supply.

The easiest most cost effective way to add automatic reversing to one section of your DCC layout.

Gray Replacement Terminal Plug for lost or damaged plugs on Digitrax Command Stations and Boosters

3 Pack Edge Connector for use with PM4 Series Boards, BDL16 Series Boards and SE8 Series Boards This is a replacement part that can be ordered through your dealer. Digitrax does not repair this item or sell directly to end users.

Decoder Wire for decoder, lighting & signal installation 90ft 30AWG stranded wire-10 ft lengths in 9 colors

The LNRP LocoNet Repeater Module Isolates and Protects LocoNet Layouts, it allows for greater expansion of the LocoNet system on large installations. The LNRP allows "protected" sections of LocoNet to continue functioning even when a fault occurs elsewhere, the LNRP automatically reconnects the faulty section once the issue is resolved.

The LT1 is included with all Digitrax Starter Sets. It consists of a harness with 6 conductor Telco type wire with a male plug, a tester with a female 6 conductor jack, and a 100 Ohm 2 watt protection resistor.

10 Pack Warm White T1 LEDs

The WTL12 is a Command Station, Booster, Throttle and Sound System that is designed by Digitrax and sold as part of the WalthersTrainline RailTech train set. It offers simplified train operation as part of a train set however the WTL12 is fully expandable with the complete line of Digitrax DCC products. It could also make a great addition to your existing Digitrax DCC system.