The EDIT Key is used to enter the Edit Mode for editing the fast clock, routes, signaling, etc.
It is also used to status edit decoders while in locomotive address selection mode.
- Routes
- Signaling
- Throttle Operation
- Throttle Operation -> Throttle Keypad Controls
- Throttle Operation -> Edit
- Throttle Operation -> Fast Clock
- Programming -> Programming Mobile Decoders -> Status Editing
- Digitrax Products -> Throttles -> DT400 Throttle-Legacy
- Digitrax Products -> Throttles -> DT402 Super Throttle
KB750: DT402 & DT400 Series Throttle EDIT Key
This article was last updated on June 2, 2011, 7:28 p.m. | Print Article | Leave Feedback
The EDIT Key is used to enter the Edit Mode for editing the fast clock, routes, signaling, etc.
It is also used to status edit decoders while in locomotive address selection mode.