KB527: DS54 - Program Enable Link

This article was last updated on Aug. 20, 2011, 7:22 p.m. | Print Article | Leave Feedback

Q:  What is the purpose of the Program Enable Link?

A:  The CV Program Enable Link is used to program the DS54.

The link (two pins) must be in the open position (one pin uncovered) for normal DS54 operation.

The link (two pins) must be in the closed position (both pins shorted by the shorting block) during the programming of the DS54.

The DS54 will behave erratically if the link is closed during normal operation.

Was this article helpful? Send us feedback!

Please let us know if this article was helpful to you.

Please leave a detailed message below.