KB451: DT402 & DT400 - Throttle Option 2 Default Decoder Status & Tetherless Operation

This article was last updated on Sept. 6, 2011, 7:54 p.m. | Print Article | Leave Feedback

Throttle Option 2

Throttle Default Decoder Status 128/28/14 speed steps

Each DT402/DT400 can be set up to operate new decoders selected by that throttle as any decoder status code you choose. New decoders are defined as decoders that have not been selected in your system.

Your throttle's default setting is to operate decoders that are 128 speed step capable, so when a new decoder is selected the throttle automaticaly assumse that all decoders selected are that 128 speed steps.

If you operate mostly decoders that are only able to recognize 28 speed steps, you can change this setting.

Tetherless Operation Mode

Each throttle can be set up with radio capability and/or infrared capability enabled, all tetherless operation disabled and power save enabled or disabled. The throttles are shipped with IR only enabled and R versions are shipped with Simplex Radio & IR enabled & the D versions are shipped with Duplex Radio and IR enabled.

Was this article helpful? Send us feedback!

Questions or Comments on this article? Please visit helpdesk.digitrax.com and submit a ticket. Please reference the KB article number in your ticket.