KB397: Installation of DN163K2 in Kato RS2 Locomotives

This article was last updated on Sept. 18, 2011, 11:33 a.m. | Print Article | Leave Feedback

The DN163K2 will fit into the Kato RS2 and RSC2 locomotives with the same frame design.

Installation for the Kato N scale SD90/43MAC is also similar.

Kapton tape should be applied in the saddle area of the frame above the motor to prevent shorting.

Install the DN163K2 decoder into the frame by tilting it slightly as you insert the front corners into the forward frame clips.

Press the decoder motor clips down over the motor contacts and slide the decoder board forward and press the board down into the frame.

Be careful not to bend the motor contacts or let them come in contact with the frame.

Was this article helpful? Send us feedback!

Questions or Comments on this article? Please visit helpdesk.digitrax.com and submit a ticket. Please reference the KB article number in your ticket.