BDL16x Series-Block Detection

1.  Install BDL16 series occupancy detector(s).  BDL16, BDL162 and BDL168 occupancy detectors can be used together on the same layout.2.  Add RX4 transponder receivers to the zones you want to set up for transponding. (You won't need to cover every detection section on the railroad for effective coverage and reporting. Some areas will be detection only sections while others will have full transponding as needed.)  Use either two RX4s with your BDL168 to set up 8 transponding zones or use one RX4 if you only need 4 transponding zones.3.  All current production Digitrax decoders are transponder equipped. If you have decoders ...

RX4 / BDL168 Hookup Worksheet BDL168 #_______ Address:________ Description______________________________________________________ Aux Power:_______ Standard BDL162 Configuration Advanced Detection Section Wiring: Transponding Method________________________________   Section Pin # Named Detection Section Description ZONE A Power In 1       1 2     Power 2 3     District 3 4       4 5     In Out Alternate Zone Comments                                             ZONE B Power In 6       5 7     Power 6 8     District ...

My question is: How do I mount the PM42? Do I need a special housing in order to mount it under table? It appears to me that mounting it flush against a surface would prevent, or make it extremely difficult, to attach the 44-pin connector. Digitrax manufactures three devices which have a 44-pin connector. These are the BDL168 (and its predecessor the BDL16), the SE8C and the PM42 (and its predecessor, the PM4). These best approach to mounting these devices is to screw the connector directly to the wiring panel board. Drill mounting holes in the end of the 44-pin ...