KB936: Marklin 6032 Command Station

This article was last updated on April 18, 2012, 2:25 p.m. | Print Article | Leave Feedback

To harmonize with NMRA’s “RP 9.2.3” programming RP, the DH140 and subsequent Digitrax decoders do not implement the “legacy” {F9} decoder interrogate instruction.

Note that this will not allow correct “address” read back on Marklin 6032 and older revision Lenz programmers that use this older {F9} instruction, and not physical register 1 read back.

Note that even though the read back will fail with no confirmation, you will always be able to write a new value correctly.

Was this article helpful? Send us feedback!

Please let us know if this article was helpful to you.

Please leave a detailed message below.