KB910: DT100 Address Programming Instructions

This article was last updated on Oct. 25, 2010, 2:12 p.m. | Print Article | Leave Feedback

These simplified DT100 operating instructions courtesy of Alan Mitchell, tested by the Raisin Valley Model Railroad Club in Blissfield, Michigan!

PROGRAMMING THE ADDRESS INTO A LOCOMOTIVE WITH A DT100


Place locomotive to be programmed on program track with the system turned on.

1. Push "Run/Stop" Button, hold it down and push the Function Button. Release both buttons (The digital display should say "Ad:--")

2. Turn the right hand throttle knob to select the address you wish to program into you throttle

3. When the number appears, push "sel" (the display should say "Page" followed momentarily by "Good"

NOTE: DT100 is out of production.

Was this article helpful? Send us feedback!

Please let us know if this article was helpful to you.

Please leave a detailed message below.