KB423: DT400/R Tetherless Operation - Programming

This article was last updated on Jan. 20, 2012, 2:40 p.m. | Print Article | Leave Feedback

Ops mode programming is the only programming method that will work while the DT400R simplex is operating as a radio throttle.

If you press the PROG Key to enter programming mode, the DT400R running as tetherless will default to the Po mode (ops mode programming).

The DT400R must be connected to LocoNet to use service mode programming and access any of the other programming modes available.

Was this article helpful? Send us feedback!

Please let us know if this article was helpful to you.

Please leave a detailed message below.