KB140: PM42 - Programming Op Switches Without a Digitrax Throttle

This article was last updated on Jan. 10, 2012, 3:45 p.m. | Print Article | Leave Feedback

Is it possible to configure the PM42 for auto reversing without a Digitrax throttle?

We're accustomed to working in the Digitrax operating environment, so our answer is theoretical at best.

However, it would seem that any operating software with a LocoNet interface could be used to set the PM42 address, using the software as a throttle in this situation.

Was this article helpful? Send us feedback!

Please let us know if this article was helpful to you.

Please leave a detailed message below.