KB1033: Verifying BDL168 Board ID is set correctly

This article was last updated on March 21, 2016, 8:49 a.m. | Print Article | Leave Feedback

Q.  How can one verify that a BDL168 board ID has been set?
 
 
A.  If you have a DT40x Series throttle:  Press PWR, then DISP, and the  2 center "Mode" letters will show "In" for 'Input following report display'.

Now any  <B2> or DS occupancy report/input messages will show in the middle 5x7 display line as:  Input number with H or L for state (high/low).

Pressing any key or moving encoder will cancel this debug usage,  and mode goes back to "Fn".

 

Was this article helpful? Send us feedback!

Please let us know if this article was helpful to you.

Please leave a detailed message below.