TL1 Single DCC Function Decoder with Integrated Transponding
TL1 Single DCC Function Decoder with Integrated Transponder
-
Your TL1 can be used as:
-
1. Function only DCC decoder with transponding
-
2. Digitrax Transponder
-
3. Function only DCC decoder without transponding.
-
Single 125mA (250mA peak) function output for lights or other functions
-
Function can be turned on/off using F0, F1, F2, F3, or F4
-
Supports both 2 digit and 4 digit addressing
-
Programmable from DCC compatible equipment
-
Configurable Strobe feature lets you simulate flashing lights like FRED, Strobes, Mars Lights, etc.
-
Compatible with Digitrax DCC Transponding Systems
-
Approximate size: 0.461” x 0.31” x 0.161” (11.7mm x 7.8mm x 4.1mm)
Specifications
- Size
- 0.461” x 0.31” x 0.161” (11.7mm x 7.8mm x 4.1mm)
- Installation
- Wired (read more)
Decoders with wires provided for hooking up the decoder in the locomotive. If wires are not provided for hooking up functions, solder pads are provided to allow you to access those functions by adding wires.
Digitrax Mobile Decoder Wire Colors
What the wires are for
Wire Color
Power Pick-up Right (Engineer's Side)
Red
Power Pick-up Left (Fireman's Side)
Black
Motor + Right Brush
Orange
Motor – Left Brush
Gray
F0(Fwd)-Forward Light
White
F0(Rev)-Reverse Light
Yellow
Lamp Common
Blue
F1-Function 1
Green
F2-Function 2
Violet
F3-Function 3
Brown
F4-Function 4
White w/ Yellow Stripe
F5-Function 5
White w/ Green Stripe
F6-Function 6
White w/ Blue Stripe
Note: DH82 & DN92 decoders, some of the very first decoders produced by Digitrax used a different wiring color code. Please check decoder spec sheets for the wire colors that were used with these decoders.